Trilio for Red Hat Virtualization
4.1
4.1
  • About TrilioVault for RHV
  • TrilioVault for RHV Architecture
  • TrilioVault for RHV 4.1 Release Notes
  • TrilioVault 4.1 Support Matrix
  • Deployment Guide
    • General requirements
    • Certificates required for TVR
    • Preparing the Installation
    • Spinning up the TrilioVault VM
    • Configure TrilioVault VM
    • Installation of RHV extensions
    • Post Installation Health-Check
    • Uninstall TrilioVault
    • Upgrade TrilioVault
  • User Guide
    • Required RHV User roles
    • Workloads
    • Preparing for Application Consistent backups
    • Snapshots
    • Restores
    • File Search
    • Snapshot mount
  • ADMIN GUIDE
    • The appliance service account
    • Configure the TrilioVault appliance login banner
    • Reset the TrilioVault GUI password
    • Shutdown/Restart the TrilioVault Appliance
    • Admin Panel
    • email alerts
    • Reporting
  • Troubleshooting
    • Important TVM Logs
    • Important RHV-Manager Logs
    • Important RHV-Host Logs
Powered by GitBook
On this page
  • Verify no snapshots or restores are running
  • Stop all TrilioVault processes
  • Main processes workloadmanager
  • Secondary processes MySQL and RabbitMQ
  • Shutdown/Restart the Appliance

Was this helpful?

Export as PDF
  1. ADMIN GUIDE

Shutdown/Restart the TrilioVault Appliance

To gracefully shut down the TrilioVault Appliance the following steps are recommended.

Not following this guide and just sending the shutdown command to the TrilioVault appliance through the RHV-M GUI/API or through the CLI is working without errors. The automated stopping of all TrilioVault services will extend the shutdown process by up to 25 minutes.

Verify no snapshots or restores are running

It is recommended to check in the RHV-M backups tab, that no snapshots or restores are running.

Stopping or restarting the TrilioVault appliance will cancel all running actively running backup or restore jobs. These jobs will be marked as errored after the system has come up again.

Stop all TrilioVault processes

Main processes workloadmanager

The following commands will stop the main processes of the TrilioVault appliance.

systemctl stop wlm-api
systemctl stop wlm-scheduler
systemctl stop wlm-workloads
systemctl stop tvault-config-api
systemctl stop tvault-object-store

Secondary processes MySQL and RabbitMQ

The TrilioVault solution is using MySQL and RabbitMQ. It is not required but recommended to gracefully stop these services too before restarting the Appliance.

systemctl stop mysql
rabbitmqctl stop

Shutdown/Restart the Appliance

Restarting through CLI of the appliance requires root privileges. The rhv_nw user will get enabled for this feature in a future update.

After the services have been stopped the Appliance can be restarted or shut down using standard Linux commands.

reboot
shutdown

PreviousReset the TrilioVault GUI passwordNextAdmin Panel

Last updated 3 years ago

Was this helpful?